4. Use of Control Pad
4.1 Button function on the control pad. ( Figure 18 )
a. "
"is operated the blind to upraise.
b. " "
is operate the blind to fall down.
c. “SET” is a setting button.
d. “STOP” is a stop button.
Please note that the installation of transmission box and
the turning direction must accord to the manual instruction.
If you install the transmission box in a wrong direction,
the function of "
" and "
" will be changed to opposite operation.
4.2 Setting the operation program
4.2.1 Setting the blind number
a. Select the blind number from 1-8. ( e.g. No.8 )
b. Use the remote control to face the transmission box, and
press the no.8 button.
( Figure 18 )
c. Press the button "SET" for 6 times that can not
exceed 10 seconds between every press action. The transmission
box is ready for setting while the Red lamp is lighted.
d. Press the “SET” button first and press ""simultaneous
until the Red lamp is flashed, then the blind number will
be selected.
4.2.2 Setting the top and the lowest position
This procedure must follow the setting of blind number ( Read
4.2.1 ) and the Red lamp is still lighted on .
a. Setting the top position. Press "
" button to operate the blind upraise until you prefer
top position, then press the "STOP" button until
the Red lamp is flashed.
b. Setting the lowest position. Press “
” button to operate the blind falling down until your
prefer lowest position, then press the "STOP" button
until the Red lamp is flashed.
c. Waiting for over 10 seconds, the setting is finished after
the Red lamp is off automatically.
Notes: You can not set blind number when the Red lamp is lighted
on. But you can set the top and the lowest position time by
time until you are satisfied.
For better outlook, there should be left 1-2 roll of blind
on the Aluminium tube when you are setting the lowest position.
4.2.3 Operation of Control Pad
a. Press"
" button to open the blind until the top position.
b. Press ""
button to close the blind until the lowest position.
c. Press "STOP" button, the blind will stop at any
prefer position.
Please do not pull the blind by force otherwise it will damage
the transmission box and the blind will fall off.
|
