Your Position: HOME >Specification > Description of romote control power curtain system

3.1 Aluminium Tube Length
The length of the tube should be cut into proper length. There are two methods for the installation.
One is inner installation: The roller blind is installed inside a window; the tube length should be 3cm less than the window width.(Figure 10)

Inner installation/Ceiling installation(Figure 10)

Another is installed over covering of the window; the tube length should be 7cm longer than the window width. (Figure 11 )

Covering window installation ( Figure 11 )

3.3 Insert the suitable blind into the groove of Aluminium tobe until they are flat in position. Then turn the tube several times according to clockwise direction that is assured the tube turning direction that is assured the tube turning direction when you are setting the operation program. ( Figure 12 ).

( Figure 12 )

3.4 Place the bottom rod and plastic cap at the bottom of the blind.
3.5 The back wheel and transmission box must be inserted into the Aluminium tube on each end. ( Fig 13 )
Notes: Please insert the shaft of the transmission box into the groove of Aluminium tube from bigger pitch and must insert the open sector of base gear into the groove the Aluminium tube

( Figure 13 )

3.6 Connect the wire for single set
3.6.1 Insert the plug of the adaptor into the transmission box. ( Figure 14 )and install the transmission box and Aluminium tube on the front shelf; also install the back wheel's side on another shelf. ( You may push the back wheel's side into the shelf by slight force until you heard a slightly "click" sound.)

( Figure 14 )

( Figure 15 )

3.6.2 Insert the plug of control pad into the correspondent socket of the transmission box. ( FIGURE 16 ).
3.6.3 Put the adaptor into the power supply socket. Please note that the adaptor must match the power voltage.

( FIGURE 16 )

Notes: If the products needn't group control, please go to the 4. Use of control pad.

3.7 Connect the wire for group control
The product can be set by group control. Customers have to prepare wire for connecting. ( We can make the wire for group control according to customers'; requirement. )
3.7.1 You have to buy the six core telephone's wire, plug and tri-connector by yourself.
3.7.2 Cut the telephone wire into suitable length according to your requirement and the number of units.
3.7.3 Use a professional clamp to fix the plug and the wire, then insert the plug into the socket of transmission on box. The plug must be inserted in the corresponding socket.

Tri-connector ( Figure 17a )

Tri - connector	Tri - connector
( Figure 17b )